FMP printing vases
- HildeMaassen
- Nov 3, 2020
- 1 min read
Updated: Nov 4, 2020
Four of the vases are being printed with an artist.
To make that happen I had to adjust the by the computer generated images because gravity exists; clay is quite heavy and can settle.
The first two were printed without to much problems but the other 2 had major problems.
This vase is printed 180 degrees turned. The bottom is seperately made and attached.
The bottom of this vase I made wider for stability. At the end it collapsed. I like the results kind of funny but not the wanted result.
As you can see, the vase at the bottom bends at the bend, collapses. I have now adjusted the vase and it will be printed again to see if it works better. (left before, right after)
It was successful printed before my adjustments were sent.
Comments